Hendrickson suspension bushing torque specs. Air Over Walking Beam Truck Suspension.

Hendrickson suspension bushing torque specs. This can lead to overtightened fasteners, unpredictable pivot connection clamp loads and unreliable axle alignments. B31 Rev LOperation name: hendrickson trailer commercial vehicle systems document name: technical procedure - trailer suspension systems; torque specifications summary: this document provides torque specifications for various fasteners equipped A torque wrench is not required to achieve the proper pivot connection torque and clamp load. AR2 series pdf manual download. Trailer SuSpenSion BolT TorQue ValueS 1 CauTion DO NOT apply anti-seize compound or additional lubricant to pivot connection hardware. This includes checking all the tightening torques of the Hendrickson HN Tandem Suspension as specified by the truck manufacturer, and as listed in the tightening torque specification chart at the end of this pu View and Download Hendrickson AR2 series service instructions manual online. spection. Air Over Walking Beam Truck Suspension. Installed weight includes complete suspension, torque rods, axle brackets and frame brackets at 54 inch axle spacing. Trailer SuSpenSion BolT TorQue ValueS 1 CauTion DO NOT apply anti-seize compound or additional lubricant to pivot connection hardware. Genuine parts, technical support, and maintenance solutions for all systems. Just tighten the shear-type bolt with an E20 TORX® socket until the bolt’s TORX head shears off. Capacities over 65K vary, contact Hendrickson engineering for more information. Table 1 recommends inspection points and intervals for suspension components and systems. This document outlines recommended inspection areas and lubrication points on Hendrickson suspensions, axles and components. . Refer to the technical procedure for the proper replacement instructions for your specific suspension The narrow bushing tool (Figure 2, also shown on front cover) is used to remove and replace pivot bushings on all INTRAAX, VANTRAAX and ULTRAA-K® suspension systems. Reference L579 Alignment Procedures. Transverse rods are standard with axle spacing of 60 inches or more and on 46,000 to 70,000 pound capacity suspensions with rubber center bushings, refer to Hendrickson publication 59310-004 and 59310-058 for more information. It is important Whether the torque rod is equipped with straddle, taper stud or hollow mount bushings, they can be replaced by pressing out the worn components and installing new Hendrickson bush-ings with the exception of torque rods designed with permanent bushings that are non-replaceable. During tightening, the bolt’s shear-head feature will shear after achieving proper torque. For an axle alignment, use two S-24705 QUIK-ALIGN® pivot bolt kits per axle for all narrow-bushing INTRAAX suspensions or two S-24679 QUIK-ALIGN pivot bolt kits per axle for all wide-bushing INTRAAX Hendrickson designs and manufactures air suspension systems and components for heavy duty trucks and trailers. Hendrickson suspension parts and service support keep your fleet running. For QUIK-ALIGN® pivot connections, a torque wrench is not required when installing a new shear-head pivot bolt and a prevailing-torque nut. vbco1rt gf afjgdq mrr4vb25 ydrlfxt 0enhw a0f tfko fomj csgyvlw